User's Manual

69
CHAPTER 5: Novell NetWare Printing
5.8.4 A SSOCIATING P RINTER O BJECTS WITH P RINT Q UEUE O BJECTS
1. From the Printer Server Configuration menu, select Queues Serviced by
Printer and press <Enter>.
2. Select the printer you want to assign a print queue to and press <Enter>.
3. Press <Insert> to add a queue to the list.
4. Select the queue that you want the printer to service and press <Enter>.
5. Enter a priority level and press <Enter>.
6. Press <Esc> until the Exit PCONSOLE dialog box appears. Choose Yes and
press <Enter>.
5.8.5 R ELOAD THE N ET W ARE PS ERVER NLM
1. Go to the console of the file server where the print server NLM is running or
will be running.
2. If you already have a print server NLM loaded, unload it now by typing
unload pserver
at the prompt. Otherwise proceed directly to step 3.
3. Reload the print server NLM by typing the following at the prompt:
load pserver pserver_name
pserver_name is the name of the existing print server NLM or of the print
server above (see Section 5.8.1).
5.8.6 C ONFIGURING THE P RINT S ERVER
After starting the print-control utility, select the desired print server from the
displayed list. The print servers are identified through their serial number and
network address. Both of these are unique to the specific print server and can be
found on the bottom of the print server as well as on the self-test print out.
Open the configuration dialog box by double clicking on the desired print server
or by highlighting the desired print server and then pressing the Configure button
displayed in the tool bar. Follow these simple steps to configure the print server as
a Novell NetWare Remote Printer.
1. Select NW Remote Printer by clicking on the white box in front of that
selection.