2-in-1 Headset Black, HS201A Blueberry, HS202A Strawberry, HS203A Grape, HS204A Lime, HS205A
FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication.
2-IN-1 HEADSET FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until the repair has been made.
CDC STATEMENT Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0). If too many devices are attached, they may not ring properly. 6. In the event of an equipment malfunction, all repairs should be performed by your supplier or an authorized agent.
2-IN-1 HEADSET CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading.
NOM STATEMENT 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación. Todo otro servicio deberá ser referido a personal de servicio calificado. 9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso.
2-IN-1 HEADSET 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18.
TRADEMARKS USED IN THIS MANUAL TRADEMARKS USED IN THIS MANUAL UL® is a registered trademark of Underwriters Laboratories Incorporated. Any other trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
2-IN-1 HEADSET Contents 1. Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 2. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 2.1 About This Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 2.2 2-in-1 Headset Components . . . . . .
CHAPTER 1: Specifications 1. Specifications Transmit: Speaker—Dynamic Volume Control Range— 18 dB (typical) Distortion—Less than 5% General: Frequency Response—300 to 3000 Hz Microphone—Noisecanceling electret Power—Current consumption: 250 µa @ 3 VDC; Operating voltage: 1.5 to 10 VDC Compliance—Registered to UL® 1459; FCC Part 68 registered; OSHA Part 1910 subpart S; CSA C22.2 No. 225-M90 Weight—1.09 oz. (30.
2-IN-1 HEADSET 2. Introduction 4. Adjustable Lobe Hinge™ 2.1 About This Guide 5. Ear Capsule This guide contains instructions for the 2-in-1 Headset. To derive maximum benefit from this versatile product, please take a few minutes to review this user’s guide. 6. Flexible Wire Headband 7. Ear Cushion (for Headband Wearing) 6. 5. 7. 4. 8. Foam Windscreen 3. 2. 9.
CHAPTER 3: Ear Capsule 3. Ear Capsule 3. With your thumb, close the ear lobe hinge until it is snug, secure and comfortable to wear, but not tight on your ear. The 2-in-1 Headset comes out of the box with the ear capsule installed ready to be worn on the right ear (see Figure 3-1). It features an Adjustable Lobe Hinge for a custom fit. To change to the left ear, see Section 3.2. 4. Lightly press the speaker against the ear for proper positioning. To remove, simply lift the 2-in-1 Headset off your ear.
2-IN-1 HEADSET 4. Push the C-ring onto the receiver housing until it springs into place in the groove (see Figure 3-5). Figure 3-3. Changing Ears. 3. Rotate 180° clockwise if you are going from right ear to left ear, counterclockwise if you are going from left ear to right ear. Figure 3-4. Removing Ear Capsule. 4. Pull down and out with your right hand, releasing the Cring from the receiver housing. 3.4 Installation 3.3 Removal 1. Remove the headband. 1. Remove the ear cushion. 2.
CHAPTER 4: Headband 4. Headband pointing to the left. 3. With your right hand, hold the headband between your thumb and index finger. The 2-in-1 Headset can also be equipped with a lightweight flexible headband. 4.1 Installation 1. Remove the ear capsule. 2. With the corded side of the receiver facing you, hold the headset in your left hand between your thumb and index finger with the boom pointing to the right. 3.
2-IN-1 HEADSET Figure 4-4. Headband Wearing. Figure 4-3. Changing Ears. 4.4 Headband Wearing Position the headset lightly on your head (see Figure 4-4). The 2-in-1 Headset headband is extremely lightweight, ensuring a comfortable fit that lasts all day. The stabilizer cushion rests just above the ear on the side of your head opposite the receiver. 14 Refer to the Microphone Positioning section (Chapter 5) for additional information.
CHAPTER 5: Microphone Positioning 5. Microphone Positioning To take advantage of the noisecanceling qualities of the microphone, position the 2-in-1 Headset with the flat side of the microphone, marked with an F, facing you. The microphone boom should be adjusted so that the microphone is approximately one finger width away from your lower lip (see Figure 5-1). The 2-in-1 Headset has a flexible boom that can be reshaped until the microphone is correctly positioned in front of your mouth.
2-IN-1 HEADSET 6. Clothing Clip The clothing clip should be fastened for comfortable wearing (see Figure 6-1). Figure 6-1. Clothing Clip. It is designed to prevent the weight of the cord from dislodging the headset. Position the clip conveniently on your clothing. To reduce excess slack, reposition the clip by sliding it up and down the cord.
CHAPTER 7: Connecting to Your Telephone 7. Connecting to Your Telephone An amplifier is needed to connect the headset to the telephone or telephone system. The headset is equipped with a Quick Disconnect plug which mates to a Quick Disconnect jack on the amplifier. Follow the instructions supplied with the amplifier to connect the headset and amplifier to your telephone or telephone system (see Figure 7-1). your headset.
2-IN-1 HEADSET 8. Maintenance The foam covers on the receiver and microphone can be washed in mild soap and water. Replacement covers are available from Black Box. Call 724-746-5500 for details. Cautionary Notes to Computer Users When using any headset with a computer, care should be taken in dry or low-humidity environments to protect the user from electrostatic discharge from the monitor (CRT).
CHAPTER 9: Troubleshooting 9. Troubleshooting 9.1 Calling Black Box If you determine that your 2-in-1 Headset is malfunctioning, do not attempt to alter or repair the unit. It contains no user-serviceable parts. Contact Black Box at 724-746-5500. Before you do, make a record of the history of the problem. We will be able to provide more efficient and accurate assistance if you have a complete description, including: • the nature and duration of the problem. • when the problem occurs.
CUSTOMER SUPPORT INFORMATION Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com 54-0182A June 2000 Printed in USA © Copyright 2000. Black Box Corporation. All rights reserved.