Specifications

724-746-5500 | blackbox.com 135

Setup

Send RS-232 String Action and RS-232 String

Check Send RS-232 String Action to send the specified RS-232 String. Clearing this setting will result in no RS-232 String

being sent.

The RS-232 String is expressed in hexadecimal format. For example: 9F 80 60 3F 00 BE

DTR (Data Terminal Read) / RTS (Ready To Send) Action

If enabled then sets the specified RS-232 Output line to the specified voltage level. If cleared, then the specified RS-232

Output line is unchanged.

Configuration

Bits per Second

Select the Baud rate in bit per second from the drop down list. The iCOMPEL currently supports rates between 110 and

460800.

Data Bits

The number of data bits to use. Select from either 7 or 8.

Stop Bits

The number of stop bits to use. Select from either 1 or 2.

Parity

The number of stop bits to use. Select from Odd or Even.

Use Local Override

If enabled, then this will use the specified Local Override settings rather then the default Channel settings.

Note: This section is only shown if the iCOMPEL is either a Channel Subscriber or a Channel Publisher.

9.3.5 Interactivity

The iCOMPEL can programmed to respond to inputs from:

USB Touch Screens

RS-232 modem control inputs

Remote Keypad Buttons

This page allows these inputs to be enabled and configured.

NOTE Some features may depend on installed feature keys.

Touch

Status

The Status field indicates the current state of the Touch system. It can indicate that:

No Touch Screen is connected

Touch Screen is connected, but is not Calibrated

Touch Screen is available