User guide

Chapter 3 : Operations
724-746-5500 l www.blackbox.com 51
Transmitter Information
The Information button provides transmitter related information such as Device Model, Serial
Number, MAC address, and current Firmware Version to the administrator.
If the active IP address is not the address of a valid InvisaPC Transmitter or this address is
unreachable, an error message is returned.
Transmitter Upgrade
The administrator can click the Upgrade button to change the firmware on a transmitter. The
upgrade file is selected from the set of files on an attached USB drive. These files will have the
extension .clu . The selected file is checked to be a valid transmitter upgrade file prior to starting
the upgrade. The OSD will provide a series of screens to walk the user through the process.
The upgrade can take several minutes to complete and the power to the Transmitter and the
Receiver must not
be disconnected during the upgrade. During the upgrade process the Transmitter
may re-boot a couple of times.
If the active IP address is not the address of a valid InvisaPC Transmitter or this address is
unreachable, an error message is returned.
Transmitter Restore Factory Defaults
The administrator can click the Restore button to reset the transmitter back to factory defaults. See
page 56 for InvisaPC Transmitter factory defaults.
If the active IP address is not the address of a valid InvisaPC Transmitter or this address is
unreachable, an error message is returned.
Transmitter Re-boot
The administrator can click the Reboot button to power-cycle the transmitter.
If the active IP address is not the address of a valid InvisaPC Transmitter or this address is
unreachable, an error message is returned.