Server User Manual

 Remove all Permitted Services. This server will be accessible using Terminal Services, so check
TCP, Port 3389 and log level 1 and click Add. Remove and re-add the service to enable logging.
 Scroll down to Nagios Settings and check Enable Nagios.
 Click New Check and select Check Ping. Click check-host-alive.
 Click New Check and select Check Permitted TCP. Select Port 3389
 Click New Check and select Check TCP. Select Port 80.
 Click New Check and select Check TCP. Select Port 443.
 Click Apply.
Similarly, you now must configure the serial port to the router to be monitored by Nagios:
 Select Serial Port from the Serial & Network menu.
 Locate the serial port that has the router console port attached and click Edit.
 Make sure the serial port settings under Common Settings are correct and match the attached
router’s console port.
 Click Console server Mode, and select Logging Level 1.
 Check Telnet (SSH access is not required, as SDT Connector is used to secure the otherwise
insecure Telnet connection).
 Scroll down to Nagios Settings and check Enable Nagios.
 Check Port Log and Serial Status.
 Click Apply.
Now you can set the console server to send alerts to the Nagios server:
 Select Alerts from the Alerts & Logging menu and click Add Alert.
 In Description enter: Administrator connection.
 Check Nagios (NSCA).
 In Applicable Ports check the serial port that has the router console port attached. In
Applicable Hosts check the IP address/DNS name of the IIS server.
 Click Connection Alert.
 Click Apply.
Finally, you need to add a User for the client running SDT Connector:
_____________________________________________________________________
724-746-5500 | blackbox.com Page 184