Server User Manual

To get the total number of managed devices:
# config -g config.devices.total
Make sure you use the total + 1 for the new device below:
# config -s config. devices.device5.connections.connection1.name=Envi4
# config -s "config. devices.device5.connections.connection1.type=EMD Unit"
# config -s config. devices.device5.name=Envi4
# config -s "config. devices.device5.description=Monitor in room 5"
# config -s config.devices.total=5
The following command will synchronize the live system with the new configuration:
# config -a
14.12 Managed Devices
To add a managed device: (also see UPS, RPC connections and Environmental)
# config -s "config.devices.device8.name=my device"
# config -s "config.devices.device8.description=The eighth device"
# config -s "config.devices.device8.connections.connection1.name=my device"
# config -s config.devices.device8.connections.connection1.type=[serial | Host | UPS | RPC]
# config -s config.devices.total=8 (decrement this value when deleting a managed device)
To delete the above managed device:
# config -d config.devices.device8
The following command will synchronize the live system with the new configuration:
# config -a
14.13 Port Log
To configure serial/network port logging:
# config -s config.eventlog.server.address='remote server ip address'
# config -s config.eventlog.server.logfacility='facility'
'facility' can be:
Daemon
Local 0-7
Authentication
Kernel
User
Syslog
Mail
News
UUCP
# config -s config.eventlog.server.logpriority='priority'
'priority' can be:
Info
Alert
Critical
Debug
Emergency
_____________________________________________________________________
724-746-5500 | blackbox.com Page 227