Specifications

Chapter 3: Configuration
Page 16 724-746-5500 | blackbox.com LGC340A
Press Enter to open the main configuration screen. This screen allows the
user to set the IP address and the destination IP address for traps with the
community string, read/write access and password as usual.
This screen contains the following information and options:
3.5.2.1 Saved and Current Values
Saved values display the changes made during the current session and current
values display the values currently in use:
• IP Address (IP address of SNMP agent)
• Subnet Mask (mask to define IP subnet to which agent is connected)
• Default Gateway (default router for IP traffic outside of the subnet)
3.5.2.2 Command List
I = Enter new Saved Parameter Values
P = Change the Password*
T = Enter new Trap Destinations
K = Remove All Trap Destinations
C = Create SNMP Community Strings
U = Delete All SNMP Community Strings
E = End the session*
Reboot = Reboot the unit (may result in short data loss)
D = Enable or disable DHCP
Space Bar = Opens the device specific configuration options screen.
Saved Values. (These values will be active after reboot)
IP Address - 10.10.10.10
Subnet Mask - 255.255.255.0 DHCP is Not Active
Default Gateway - 0.0.0.0
Current Values. (These values are in use now)
IP Address - 10.10.10.10
Subnet Mask - 255.255.255.0
Default Gateway - 0.0.0.0
Community String: public Access: r/w
Press I to enter new saved parameter values. Press P to change Password.
Press T to enter new Trap Destination. Press K to remove All Trap
Destinations.
Press C to enter new Community String. Press U to remove All Community
Strings.
Press E to End session. Type REBOOT to reboot unit. Press D for DHCP
On/Off.
Press SpaceBar for additional commands.