Modem User Manual

138
Modem 34336
Primary Options:
addr
999 999
Group Unit
address address
Figure C-2. How to move the cursor
in the SETUPS screen using the
pushbuttons.
Dial Line Options:
dial
11111002210
Pulse dialing rate (pulses per sec): 0=10, 1=20
Wait for carrier (sec): 0=30, 1=45, 2=60, 3=75
T1 timer (sec): 0=0, 1=0.3, 2=0.8, 3=1.6, 4=3.0
Carrier detect level, dial (dBm): 0=-26,1=-33, 2=-43
TX level, dial: 0=permissive, 1=programmable
Disconnect, RTS (sec): 0=off, 1=140, 2=120. . . 7=20
Disconnect, line current: 0=disable, 1=enable
Disconnect, carrier: 0=disable, 1=enable
Disconnect, TX space: 0=disable, 1=enable
Disconnect, RX space: 0=disable, 1=enable
Auto-answer: 0=disable, 1=enable
EIA INTERFACE OPTIONS:
e i a
010211000
Test mode: 0=normal, 1=true
Remote digital loopback test: 0=disable, 1=enable
Analog loopback test: 0=disable, 1=enable
CTS: 0=normal, 1=follow RTS, 2=true, 3=on
Carrier detect: 0=normal, 1=true, 2=toggle
DSR: 0=true, 1=normal, 2=crossover
DTR: 0=normal, 1=true
Increase
the value of
the blinking
character
by one
TRANSMITTER RECEIVER
Move the
cursor one
position to
the left
Move the
cursor one
position to
the right
Exit to the
AT Profiles
Screen
Move the
cursor to
the next
section of
commands
Move the
cursor to
the previous
section of
commands