Modem User Manual

Modem 34336

Table 5-1 (continued). Hayes Compatible Commands.

COMMAND FUNCTION/EXPLANATION

S= Modify S Register

Parameters are register and value to be written.

S? Read S Register

Parameter is the register number.

T Tone Dialing

No parameters.

V Word/Digit Result Code

V0 Result codes are transmitted as digits.

V1 Result codes are transmitted as words.

W Wait For Dial Tone

No parameters, but default wait time (register S7) is

30 seconds.

X Select Result Code

X0 Selects basic result codes, 0-4. No speed indication;

no busy or dial tone detect.

X1 Selects result codes 0-5, 10, 11, 13, 14, 15, and 18.

Connection speed (up to 14,400 bps) indicated; no

busy or dial tone detect.

X2 Selects result codes 0-6, 10, 11, 13, 14, 15, and 18.

Same as X1 except dial tone detect is enabled.

X3 Selects result codes 0-5, 7, 10, 11, 13, 14, 15, and 18.

Same as X1 except busy-signal detect is enabled.

X4 Selects all result codes. Connection speed (up to

14,400 bps) indicated; busy-signal and dial-tone detect

enabled.

Note: Result code 8 is independent of the X command;

it is displayed only when the @ dial modifier is used.

Default settings (where applicable) are in bold face.

* If user profile 1 is active, options are controlled (for Hayes mode

operation) by given commands or Summary Setup. Do not change via

front panel (except via Summary Setup).