Specifications

T1/E1 LINK EXTENDERS
9
2. Installation
Because the T1/E1 Extenders require no configuration, they can be installed
quickly. Installation consists of the following:
•
Connect the power plug (refer to section 2.1, “Connecting Power” on page 10).
•
Connect the line port (refer to section 2.3, “Connecting the Line Port” on
page 11)
Note See Figure 1 and Figure 2 for the rear-panel connectors locations.
•
Connect the T1/E1 port (refer to section 2.4, “Connecting the Circuit Interface”
on page 11).
Figure 1. Model MT196A-E1 rear panel
Figure 2. Model MT195A-T1 rear panel
Made in the USA
Power
Power
Line
Line
TX
Interface
RX
RX (75 Ohm)
(Data from
G.703/G.704
network)
TX (75 Ohm)
(Data to
G.703/G.704
network)
E1 interface
(120 Ohm)
Made in the USA
Power
Power
Line
Line
Interface
T1 interface
(RJ-48C)