AUGUST 2007 AC1100A AC1101A AC1102A Multi DVI System CATX Series © Copyright 2007. Black Box Corporation. All rights reserved. 1000 Park Drive • Lawrence, PA 15055‐1018 • 724‐746‐5500 5310196-01 02 • Fax 724‐746‐0746 CUSTOMER SUPPORT INFORMATION Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S.
MULTI DVI SYSTEM. FCC/IC RFI STATEMENTS, EU DECLARATION OF CONFORMITY FEDERAL COMMUNICATIONS COMMISSION FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS AND This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication.
CHAPTER 1: Specifications MULTI DVI SYSTEM. 1.Specifications 2. Introduction Cable Required: Between transmitter and receiver: Cat5/Cat6 Compliance: CE; FCC Class A, IC Class A Video Support: DVI Single Link The Multi DVI System extends DVI video signals over Cat5/6 cable. All models support single link DVI video modes. Resolution: 1600x1200 , 1080P (if graphics card supports reduced clock rate) This manual covers Multi DVI System units for video (AC1100A, AC1101A, AC1102A).
CHAPTER 3: Setup and Installation 3. Setup and Installation MULTI DVI SYSTEM. 3.2.2 CONNECTIONS ON THE SINGLE-PORT MULTI DVI The AC1100A, AC1101A, AC1112A units support DVI video over CAT5 cable . 3.1 Cabling Considerations • We recommend mounting and connecting all cabling to the Multi DVI System components before applying power. Please note recommended power sequence below. Figure 3-1 shows the video only Multi DVI System Transmitter connections, and Figure 3-2 shows the receiver connections. 3.
CHAPTER 3: Setup and Installation MULTI DVI SYSTEM. 4. Troubleshooting 3.2.3 CONNECTIONS ON THE DUAL DAISYCHAINABLE RECEIVER The dual daisychainable receiver is used when the same signal is distributed to multiple display devices on a single cable in a daisychain or loop-through fashion. CAT5 Cable lengths must not exceed 600 ft between units. 4.1.
APPENDIX A:Cabling Pinouts MULTI DVI SYSTEM. Appendix B. Status LED’s Appendix A. Cabling Pinouts The Multi DVI System feature “status-at-a-glance” LED’s to ensure the units are functioning properly and to isolate problems with input signals, units, and/or cabling thus saving time during installation and troubleshooting. Reference the following tables for information on theses indicators.
APPENDIX C:Compression Mode MULTI DVI SYSTEM. APPENDIX D. DDC Modes Appendix C. Compression Mode The Multi DVI System features two video compression modes to enable high resoluiotn video extension over long distances. Compression modes may be changed with a simple jumper setting accessible through the front cover. All units must be set to the same compression mode for proper operation. The two modes are: Pixel Compression mode. Suitable for static non motion content.
APPENDIX D:DDC modes APPENDIX D. DDC Modes MULTI DVI SYSTEM. Appendix E. Rackmounting Units The Rackmount Kits include brackets for mounting a transmitter, receiver, or a dual daisychainable receivers in a 19 rack. Figure F-1 shows the 2-Unit Rackmount Bracket (AC1011), which holds three units in a 19" x 1U rack. Not shown are brackets for 6 units . The 6-Unit Transmitter/Receiver Bracket (AC1012) is like the AC1011 but occupies 2U of space instead of 1U in a 19" rack, stacking 3 units atop 3 units.
MULTI DVI SYSTEM.