User's Manual

32
ETHERNET TO TWINAX/COAX PRINT SERVER
If there is not an AnyNet controller already configured on the AS/400, you
will have to create one.
If you are not following Black Box’s recommended method of using only one
AnyNet controller for all your AnyNet devices (including print servers), the
AnyNet controller name and the AnyNet remote control name must be
different from the print server Name. If your AS/400 is using more than 254
AnyNet devices, you should configure one AnyNet controller for every print
server. In this case, the name of the AnyNet controller and the AnyNet
remote control point must be the same as the print server name. The AnyNet
controller name can be up to 10 characters long.
7. AnyNet Remote Control Point Name: _____________________
If you already have an AnyNet Controller defined on your AS/400 and plan to
use the print server under this controller, do the following:
On the AS/400 command line, type WRKCTLD and press <Enter>.
Locate the AnyNet Controller, enter the value “5” in front of that controller,
and press <Enter>.
Locate the Remote Control Point and enter the value in the worksheet space
above.
Otherwise, if you are not following Black Box’s recommended method of
using only one AnyNet controller for all your AnyNet devices (including print
servers) and you are creating a new AnyNet controller, the AnyNet Remote
Control Point Name should be different from the print server name.
If your AS/400 supports more than 254 AnyNet devices, you should configure
one AnyNet controller for every print server. In this case, the AnyNet Remote
Control Point Name should be the same as the print server name.
4.5.2 C ONFIGURING THE AS/400 FOR A NY N ET
Changing the AS/400’s Network Attribute
To allow AnyNet communication from your AS/400, the Allow AnyNet Support
option must be set to *Yes. You may want to check the current setting first by
executing the DSPNETA command and then scrolling to the last page of the
available parameters. If the value is set to *No, return to the command prompt
(CMD3) and enter the following:
CHGNETA ALWANYNET (*YES)