User's Manual

ETHERNET TO TWINAX/COAX PRINT SERVER

4.7 Configuring Windows NT V4.x

Make sure your Windows NT workstation has the TCP/IP protocol and the

TCP/IP Printing service active. If you are unsure do the following:

1. Click on Start, then select Settings, and lastly Control Panel.

2. Double-click on the Network icon and review the lists under the Protocol and

Services tabs.

If the TCP/IP protocol and Microsoft TCP/IP Printing service are not found, you

must add them before continuing with the instructions below. Consult your

Microsoft documentation for more information.

Follow the procedures below to create printers for the print server on a Windows

NT workstation. If there is more than one printer attached to the print server,

perform this procedure once for each attached printer:

1. From the Windows NT desktop, click on Start.

2. Select Settings, then open the Printer folder.

3. Double click on the Add Printer icon.

4. Choose My Computer.

5. Select Add Port.

6. From the Available Printer Ports list, double-click on LPR Port.

7. In the Name or address of server providing lpd: field, enter the IP address

you assigned to the print server (see Section 4.1.1).

8. In the Name of printer or print queue on that server: field, enter the physical

or logical port of the print server that the target printer is attached to (that is,

LPT1, TCP1)

NOTE

Selecting the TPC1 logical port will give you added configuration

options, such as turning banner (header and trailer) pages off and

suppressing blank pages when printing to an HP LaserJet printer.

9. Click OK and Close the Printer Ports screen.

10. From the Add Printer Wizard screen, select the LPR port you just added and

press Next.