User's Manual

45
CHAPTER 5: Novell NetWare Printing
ii. Click New.
iii.Enter a name of your choice in the Printer Agent (PA) Name field.
3. Click on the Novell Printer Gateway and then click OK.
4. If the NDPS Manager has not been loaded before, you will now be prompted
to do so. Click OK, then respond with OK again.
5. Select the most appropriate Printer Type and then highlight the Novell Port
Handler in the bottom window. Click OK.
6. Select the appropriate Connection Type (see below).
a. Remote (printer on IPX)
b. Remote (LPR on IP)
c. Forward Jobs to a Queue
NOTE
The last option (Forward Jobs to a Queue) should only be selected if
you have already created and linked the following NDS objects: Print
Server, Printer, and Print Queue. You also should have configured the
print server for NDS Print Server mode printing. See Section 5.3.
7. If you selected Remote (printer on IPX), select Port Type Other.
8. Click Next.
a. If you selected Remote (printer on IPX), specify a SAP Name and a Port
Number. These values will later be used to configure the print server.
(Note: The SAP Name is specific to the print server. If multiple printers
are attached to the print server, then the SAP Name should be different
from the name of the Printer Agent, since it will be shared by the other
printer[s].)
b. If you selected Remote (LPR on IP), enter the print server’s IP address in
the Host Address field. In the Printer Name field, enter TCPx, where x
corresponds to the print server’s physical port(s).
c. If you selected Forward Jobs to a Queue, enter the Queue Name that is
associated with the print server and a Queue User Name.