User's Manual

CHAPTER 5: Novell NetWare Printing

7. Press <Esc> several times until the Exit? menu appears. Select Yes and press

<Enter>.

8. If you are installing a new print server, proceed to Section 5.4.4. Otherwise,

reset the print server by powering it OFF and back ON again or by using the

Reset button in the print-control utility.

5.4.4 C

ONFIGURING THE

RINT

ERVER

After starting the print-control utility, select the desired print server from the

displayed list. The print servers are identified through their serial number and

network address. Both of these are unique to the specific print server and can be

found on the bottom of the print server as well as on the self-test print out.

Open the configuration dialog box by double clicking on the desired print server

or by highlighting the desired print server and then pressing the Configure button

in the tool bar. Follow these simple steps to configure the print server as a Novell

NetWare 4.x NDS Print Server:

1. Select NW Print Server by clicking on the white box in front of that selection.

2. The column titled “Object Information” will display the available

configuration parameters.

a. Replace the default Print Server Name (the Black Box serial number)

with the Print Server Name assigned during Adding a Print Server Object

(see Section 5.4.1).

b. If necessary enter the Password for this print server object and change the

Ethernet [frame] Type and the Queue Polling Time.

The Queue List and Notify List are for information only. This information

must be changed on the Novell NetWare server.

3. In the left column of the print-control screen, click on the white circle in

front of NDS.

4. Then click the NDS button.

5. The column titled “Object Information” will display the available

configuration parameters. Enter the name of the correct NDS Tree and NDS

Context manually or using the Browse button.