User's Manual

ETHERNET TO TWINAX/COAX PRINT SERVER

2. The Host Network ID is listed as the Local network ID and the Host Control

Point Name is listed as the Local control point name.

6.2.3 AS/400 A

UTO

-C

ONFIGURATION

Make certain that the AS/400 is set up for auto-configuration of new devices by

doing the following:

1. On the AS/400 command line, type DSPSYSVAL SYSVAL (QAUTOCFG),

then press <Enter>. The Auto Configure device parameter should be set to

1=ON.

2. On the AS/400 command line, type DSPSYSVAL SYSVAL (QATORMT),

then press <Enter>. The Auto Configure Remote Controller parameter

should be set to 1=ON.

3. On the AS/400 command line, type DSPSYSVAL SYSVAL (QAUTORMT),

then press <Enter>. The Number of devices to autoconfigure should be large

enough to account for all virtual (APPC) devices on your network. If you are

unsure, you may want to increase this number.

4. On the AS/400 command line, type WRKLIND, then press <Enter>. Enter a 5

to display, or 2 to change in front of the line that the print server is attached

to. Press <Enter> several times until Autocreate controller is displayed in the

lower section of the menu options. Verify that the Autocreate controller

parameter is set to *Yes.