User's Manual

ETHERNET TO TWINAX/COAX PRINT SERVER

3. Enter the ping command again from the MVS system. If you receive a

successful response to the ping command, there is a duplicate IP address.

Consult your system administrator.

8.2.6 D

EFINE THE

RINTER TO

JES

When an print server is used with JES, it must be defined for deferred printing

mode with JES.

• The JES2 printer definition initialization member, located in the system

PARMLIB is shown below:

FSS (FSS1), PROC=PSFPROC,HASPFSSM=HASPFSSM

PRT1 FSS=FSS1,MODE=FSS,PRMODE= (LINE,PAGE,SOSI1),

CLASS=C, UCS=0, SEP, NOSPEPDS, CKPTPAGE=100

DRAIN, MARK, TRKCELL=YES

The above example is correct for JES2 3.11 and above. For earlier versions of

JES2, the statement is FSSDEF and would be stated as FSSDEF

FSSNAME=FSS1.

The value specified for the PROC parameter must match the name on the

PSF/MVS startup procedure.

• The JES3 printer definition is shown below. This example is not executable,

but is intended to help the JES3 systems programmer define the printer to the

MVS host.

FSSDEF, TYPE=WTR, FSSNAME=FSS1, PNAME=PSFPROC,

SYSTEM=SYS1, TERM=NODEVICE, JNAME=PRT1,

JUNIT=(,SYS1,,OFF), FSSNAME=FSS1, MODE=FSS,

PM=(LINE,PAGE,SOSI1),CHARS=(YES,GT12),

The value specified for the JNAME parameter must match the name of the

printer in the PSF/MVS startup procedure.

The value specified for the PNAME parameter must match the name on the

PSF/MVS startup procedure.