User`s guide

CHAPTER 13: Command Reference Guide
113
/W Display Port Parameters (Who)
Displays configuration information for an individual port, but does not allow the
user to change parameters. Accounts that do not permit Supervisor commands can
only display parameters for their resident port. For more information, please refer to
Section 6.4.
Availability: Supervisor / Non-Supervisor
Format: /W [x] [Enter]
Where x is the port number or name. To display parameters for the Network Port,
enter an “N”. If the “x” argument is omitted, parameters for your resident port
will be displayed.
Response: Displays port parameters.
Example: To display parameters for a port named “SERVER”, access the Command
Mode from a port and account that permits Supervisor commands, and type
/W SERVER [Enter].
/X Exit Command Mode
Exits command mode. When issued at the Net Port, also ends the Telnet session.
Note that exiting from command mode will not terminate port connections.
• Any-to-Any Mode: Exits command mode.
• Modem Mode: Disconnects and resets modem, hang-up message is sent,
hardware line to modem drops for 500 ms, and reset message is sent.
Availability: Supervisor / Non-Supervisor
Format: /X [Enter]
Response: Disconnected.