UK Ireland Australia New Zealand
Intended use Your Black & Decker battery charger is designed to charge lead-acid batteries. This product is intended for household, consumer use only. Safety instructions Warning! When using mains-powered appliances, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock, personal injury and material damage. X Read all of this manual carefully before using the appliance. X The intended use is described in this manual.
Make sure that the initial charging rate does not exceed the battery manufacturer's requirement. Warning! Risk of explosive gas mixtures. Working in the vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal battery operation. For this reason, it is of utmost importance that each time, before using your battery charger, you read this manual and follow the instructions exactly.
For most automotive and similar applications the battery charger may be connected to the battery while it is connected to the dc circuit. If this is acceptable follow the instructions given in "Charging a battery installed in the circuit". X If the battery must be disconnected from the circuit before charging, follow the instructions given in "Charging a battery disconnected from the circuit". Warning! A marine (boat) battery must be removed and charged on shore.
Stage 3 - top-off charge Stage 3 is a top-off charge. The voltage is automatically regulated and is reduced to a predetermined level while the current is adjusted for a safe, effective battery charge. At the conclusion of stage 3, the appliance will beep, signalling the completion of the charging cycle. Function pushbuttons (fig. A) The function pushbuttons on the control panel (3), from left to right, are: SLOW/FAST pushbutton (11) (charge rate selector step 2).
Part 1 (no load) X Make sure that there is no load on the alternator by turning off all the vehicle's accessories. X The battery must be fully charged before testing the alternator. X Run the engine long enough to achieve normal idle speed and verify that there is a no-load voltage. X Press the alternator check pushbutton (9) to start the check.
F01 - Internal shorted cell battery Protecting the environment If the battery being charged has an internal shorted cell, F01 will be displayed. We recommend taking your battery to a certified automotive service centre for evaluation. Should you find one day that your appliance needs replacement, or if it is of no further use to you, think of the protection of the environment.
Technical data Input voltage Rated input Output voltage Output current Weight Vac W Vdc A kg BDV1084 230 180 12 2/6/10 1.93 Black & Decker repair agents and full details of our aftersales service and contacts are available on the Internet at: www.2helpU.com Please visit our website www.blackanddecker.co.uk to register your new Black & Decker product and to be kept up to date on new products and special offers. Further information on the Black & Decker brand and our range of products is available at www.
$XVWUDOLD %ODFN 'HFNHU $XVWUDOLD 3W\ /WG )OHWFKHU 5RDG 0RRURROEDUN 9LFWRULD 1HZ =HDODQG %ODFN 'HFNHU 7H $SXQJD 3ODFH 0W :HOOLQJWRQ $XFNODQG 8QLWHG .