User Manual

11
ENGLISH
Protecting the Environment
w
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal householdwaste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to produce
sufficient power on jobs which were easily done before. At the end
of its technical life, discard it with due care for ourenvironment:
• Run the battery pack down completely, then remove it from
thetool.
• Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed ofproperly.
Optional Accessories

WARNING: Since accessories, other than those offered by
BLACK+DECKER, have not been tested with this product,
use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only BLACK+DECKER
recommended accessories should be used with
thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
D
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing thisprocedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non‑metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into aliquid.
C
Lubrication
Your power tool requires no additionallubrication.
operation contact your local authorised service centre for repairs
before putting it back intouse.
1. Remove thebattery.
2. Remove blade from pruner. See instructions for Removing
and InstallingBlade.
3. Wear proper eye protection and gloves and be careful not
to cutyourself.
4. Secure blade
5
in a vise
12
as shown in Fig.G.
5. Carefully file the cutting edge
15
of the cutting blade with
a fine tooth file
14
(not included) or sharpening stone (not
included), maintaining the angle of the original cuttingedge
of the cuttingblade.
6. Inspect the edge of the fixed blade and remove any burrs
with a fine toothfile.
7. Install sharpened cutting blade as described in the
Removing and InstallingBladesection.
Blade Lubrication (Fig.A)
1. After use, remove thebattery
7
.
2. Carefully apply a resin solvent to the exposedblades.
Storage (Fig.A)

WARNING: Keep your hands away from theblade.
1. After use, remove thebattery.
2. Store in a dry location, away from the reach ofchildren.