Installation Guide
8
2. Insert the bit or other accessory fully
by holding the handle and rotating the
chuck clockwise as viewed from the
chuck end.
WARNING: Do not attempt to tighten
the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury
may occur when changing accessories.
ON BOARD BIT HOLDER (FIGURE G)
area just above the battery pack.
LED WORK LIGHT (FIGURE G)
When the drill is activated by pulling the trigger
will automatically illuminate the work area.
NOTE: The work light is for lighting the
immediate work surface and is not intended
to be used as a flashlight.
SCREW DRIVING
should be pushed to the left. Use reverse
fasteners. When moving from forward to
trigger switch first.
AUTOSENSE
This tool is equipped with
AUTOSENSE
technology that automatically stops most
screws flush.
is pushed to the left and drive mode is
selected (Figure E
to drive a
screw into the workpiece and the tool
will automatically stop when the screw is
flush to the workpiece.
hold the trigger switch. After a moment
the drill will begin to make short rotations
to drive the screw deeper at a more
controllable pace.
release the trigger switch.
NOTE: Similar to traditional drill/drivers – it is
important to apply firm pressure to the back
of the drill to ensure the screw bit doesn’t slip
out of the screw head. If the screw bit does
slip out reinsert the screw bit and increase
your pressure to the back of the tool.
NOTE: If the tool stops before the screw
AUTOSENSE Technology.
NOTE: AUTOSENSE Technology works
certain materials or screws.
DRILLING
is pushed to the left and drill mode is
selected (Figure E
be deactivated.
instructed in the Safety Instructions.
as instructed in the Safety Instructions.
instructed in the Safety Instructions.
to keep the drill bit from slipping out of it.
bit. Use enough pressure to keep the bit
biting but not so much as to stall the motor
or deflect the bit.
WARNING: When this tool is in drill
mode it may stall if overloaded,
causing a sudden twist.
Hold the drill firmly with two hands to
control its twisting action.
STALLED DRILL OFF AND ON IN AN
ATTEMPT TO START IT. DAMAGE TO
reducing pressure and slowly drilling
through the last part of the hole.
the bit out of a drilled hole. This will help
reduce jamming.
Make sure switch turns drill on and off.
DRILLING IN WOOD
Holes in wood can be made with the
same twist drill bits used for metal or with
spade bits. These bits should be sharp
and should be pulled out frequently when
drilling to clear chips from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass
which should be drilled dry. The cutting
lubricants that work best are sulfurized
cutting oil or lard oil.
G
9
8