Manual

9
TORQUE CONTROL - FIGURE F
This tool is fitted with a torque adjustment

to set the torque for tightening screws. Large
screws and hard workpiece materials require
a higher torque setting than small screws and
soft workpiece materials.
 
the collar to the drilling position symbol
 
desired setting. If you do not yet know the
appropriate setting, proceed as follows:
 
setting.
 
 
desired result is achieved, increase
the collar setting and continue
tightening the screw. Repeat until you
reach the correct setting. Use this
setting for the remaining screws.
BIT TIP STORAGE

area on the top of the tool.
LED WORK LIGHT
When drill is activated by pulling the trigger

will automatically illuminate the work area.
NOTE: The work light is for lighting the
immediate work surface and is not intended to
be used as a flashlight.
DRILLING


instructed in the Safety Instructions.

as instructed in the Safety Instructions.

in the Safety Instructions.

until the hole is started enough to keep the
drill bit from slipping out of it.

Use enough pressure to keep the bit biting
but not so much as to stall the motor or
deflect the bit.
Hold the drill rmly with two hands to
control its twisting action.

STALLED DRILL OFF AND ON IN AN
ATTEMPT TO START IT. DAMAGE TO THE


pressure and slowly drilling through the last
part of the hole.

of a drilled hole. This will help reduce jamming.
Make sure switch turns drill on and off.
DRILLING IN WOOD
Holes in wood can be made with the same
twist drill bits used for metal or with spade
bits. These bits should be sharp and should
be pulled out frequently when drilling to clear
chips from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals.
The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that
work best are sulfurized cutting oil or lard oil.
MAINTENANCE
Use only mild soap and damp cloth to clean
the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance and

should be performed by authorized service
centers or other qualified service personnel,
always using identical replacement parts.
ACCESSORIES
WARNING: The use of any accessory not
recommended for use with this tool could be
hazardous.
Recommended accessories for use with your tool
are available from your local dealer or authorized
service center. If you need assistance regarding
accessories, please call: 
F
13