5 2 4 3 www.blackanddecker.com.au www.blackanddecker.co.
(Original instructions) ENGLISH 6a Charging 5 Fully Charged Hot/Cold Pack Delay Bad Battery 6 B A 5 5a 5 C D 7 E 2 9 9 8 F
(Original instructions) 11 10 G G1 2 2a Intended use Your BLACK+DECKER BDCDS18 sander has been designed for sanding wood, metal, plastics and painted surfaces. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ 11 10 4 H ENGLISH Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injur .
ENGLISH (Original instructions) 3. Personal safety a. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. b. Use personal protective equipment. Always wear eye protection.
(Original instructions) u u Hold power tool by insulated gripping surfaces when performing an operation where the sanding accessory may contact hidden wiring. Accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control.
ENGLISH u u u u u (Original instructions) Do not expose the battery to water. Do not store in locations where the temperature may exceed 40 °C. Charge only at ambient temperatures between 10 °C and 40 °C. Charge only using the charger provided with the tool. When disposing of batteries, follow the instructions given in the section "Protecting the environment". Do not attempt to charge damaged batteries.
(Original instructions) Item Description 120 grit detailed finger sanding sheet. For a medium finish for detailed sanding (Part Number - X3277-XJ) Charging procedure (Fig. A) BLACK+DECKER chargers are designed to charge BLACK+DECKER battery packs. u Plug the charger (6) into an appropriate outlet before inserting the battery pack (5). u Insert the battery pack (5) into the charger (6) as shown in figure A. u The LED (6a) will flash indicating that the battery is being charged.
ENGLISH (Original instructions) Assembly Warning! Before assembly, make sure that the tool is switched off and the battery is removed. Fitting sanding mesh (Fig. E) u u Hold the tool with the sanding base facing upwards. Place the sanding mesh (7) onto the sanding base, making sure that the holes in the sheet line up with the holes in the base. Fitting sanding sheets (Fig. F - Optional accessory) Detach the two additional diamond-shaped tips (9) from the sanding sheet (8).
(Original instructions) EC declaration of conformity Technical data BDCDS18 18 Input voltage Vdc Oscillations (no load) min-1 12000 Orbits (no load) min-1 12000 Sanding base surface mm2 8866 Weight kg 0.85 BL1518 Battery Voltage Capacity ENGLISH VDC 18 Ah 1.
N521274 03/2017
