Installation Guide

6
• If necessary, wash the two filters (12
and 13) in warm, soapy water.
• Make sure that the filters are dry
before refitting them to the appliance.
•Refitthepleatedfilterintotheplastic
pre-filter.
•
Refitthepre-filterintothedustcontainer(10)
until it locks into place.
•Closethetransparentdoorand
make sure it clicks into place. Refit to
appliance.
CLEANING THE DUST
CONTAINER (FIG. I, J)
WARNING: Projectile/Respiratory Hazard: Neverusetheappliance
without the filters. Optimum dust collection will only be achieved with clean filters.
CAUTION: Donotturn
appliance on when dust container is removed.
•Pushandholdthereleasebowlbutton
(5)onthedustcollector.
•Rotatethehandletowardthebottomof
the appliance.
•Pullthedustcontainertotheside,and
away from the base of the appliance.
NOTE: You can then remove the filters
as described above, or remove only the
pleatedfilter(13) by pulling it firmly from the
nowexposedside.
• Oncefiltersareremoved,wipethedust
container with a damp cloth, or rinse with
warm soapy water and allow to dry as
shown in figure J.
•T o replace the dust container, with the
filters installed slide the container back
onto the base and rotate the handle toward
the front of the appliance until an audible
clickisheard.Ensurethatthecontaineris
fully fastened back onto the base.
REPLACING THE FILTERS
The filters should be replaced every
6to9monthsandwheneverwornordamaged.Replacementfiltersareavailablefrom
yourBlack+Deckerdealer(cat.no.PVF110):
•Removetheoldfiltersasdescribedabove.
•Fitthenewfiltersasdescribedabove.
I
H
12 13
J
10