GL4525 GL5028 GL5530
B A 2 5 C D E F 2
G H I J K L 3
M N O P Q R 4
S T U 5
ENGLISH (Original instructions) Intended use Your Black & Decker trimmer has been designed for trimming and finishing lawn edges and to cut grass in confined spaces. This appliance is intended for consumer use only. Safety of others u Safety instructions Warning! When using mains-powered appliances, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock, personal injury and material damage.
(Original instructions) Using an extension cable Always use an approved extension cable suitable for the power input of this appliance (see technical data). The extension cable must be suitable for outdoor use and marked accordingly. Up to 30 m of 1.5 mm2 HO5VV-F extension cable can be used without loss of product performance. Before use, inspect the extension cable for signs of damage, wear and ageing. Replace the extension cable if damaged or defective.
ENGLISH u u (Original instructions) If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Electric safety can be further improved by using a highsensitivity 30 mA Residual Current Device (RCD). Features This appliance includes some or all of the following features. 1. On/off switch 2. Handle 3. Cable restraint 4. Power inlet 5. Second handle 6. Guard 7. Spool housing 8. Head 9.
(Original instructions) Edging mode (fig. I & J) For edging, the trimmer head should be in the position shown in fig. I. If it is not: u Disconnect the tool from the supply. u Loosen the adjustment collar (6) by turning it clockwise. u Whilst holding the handle (2), rotate the head (8) anti-clockwise. u Tighten the collar (6) by turning it anti-clockwise. u Slide the edge guide out of the motor housing. Ensure that the edging guide (9) is fully extended, an audible click will be heard.
ENGLISH (Original instructions) Bend the cutting line and anchor it in the L-shaped slot (30). u Wind the cutting line onto the spool in the direction of the arrow. Make sure to wind the line on neatly and in layers. Do not criss-cross (fig. R). u When the wound cutting line reaches the recesses (31), cut the line. Let the line protrude approx. 12 cm from the spool and hold a finger on the line to keep it in place (fig. Q). u Proceed as described above to fit the spool on the tool.
ENGLISH (Original instructions) u u u Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner. Regularly clean the cutting line and spool using a soft brush or dry cloth. Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard. Technical data Protecting the environment Z Separate collection. This product must not be disposed of with normal household waste.
ENGLISH (Original instructions) EC declaration of conformity MACHINERY DIRECTIVE OUTDOOR NOISE DIRECTIVE % GL4525/GL5028/GL5530 Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60335-1, EN 60335-2-91 2000/14/EC, Lawn Trimmer, L ≤ 50 cm, Annex VIII KEMA Quality B.V., Utrechtseweg 310, 6802 ED Arnhem, The Netherlands Notified Body ID No.
TYP. GL5530 1 Partial support - Only parts shown available Nur die aufgefuerten teile sind lieferbar Reparation partielle - Seules les pieces indiquees sont disponibles Supporto parziale - Sono disponibili soltanto le parti evidenziate Solo estan disponibles las peizas listadas So se encontram disponiveis as pecas listadas Gedeeltelijke ondersteuning - alleen de getoonde onderdelen zijn beschikbaar 10 1 2 3 8 7 9 4 5 6 E16196 www.2helpU.
TYP. GL4525 - GL5028 1 Partial support - Only parts shown available Nur die aufgefuerten teile sind lieferbar Reparation partielle - Seules les pieces indiquees sont disponibles Supporto parziale - Sono disponibili soltanto le parti evidenziate Solo estan disponibles las peizas listadas So se encontram disponiveis as pecas listadas Gedeeltelijke ondersteuning - alleen de getoonde onderdelen zijn beschikbaar 11 10 1 2 3 7 8 9 5 4 6 E16197 www.2helpU.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90568682 REV-2 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.