www.blackanddecker.
17 16 15 15 A 14 18 B 12 25 20 26 24 C 19 21 9 22 D 23 28 29 E 2 29 28 30 27 F
4 G H 5 2 6 1 31 I J K K 3
11 7 L 4 M
Intended use Your Black & Decker strimmer has been designed for trimming and finishing lawn edges and to cut grass in confined spaces. This tool is intended for consumer use only. Your Black & Decker charger has been designed for charging the battery in the tool with which it was supplied.
◆ ◆ ◆ ◆ Warning! The battery fluid, a 25-30% solution of potassium hydroxide, can be harmful. In case of skin contact, immediately rinse with water. Neutralise with a mild acid such as lemon juice or vinegar. In case of eye contact, rinse abundantly with clean water for at least 10 minutes. Consult a physician. Additional safety instructions for grass trimmers The following warning symbols are found on the tool: Wear safety glasses or goggles when operating this tool.
5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Handle knob Handle adjustment collar Mode adjustment collar Motor housing Guard Line trimming blade Edge guide Spool housing Cutting line Battery Fig. A 15. Charger 16. Charging indicator 17. End of charge indicator Assembly Warning! Before assembly, remove the battery from the tool. Fitting and removing the battery (fig. B) ◆ To fit the battery (14), line it up with the receptacle on the tool.
3 hour charger The battery will be fully charged in approx. 3 hours. It can be removed at any time or left in the connected charger indefinitely. 1 hour charger ◆ Check if the red charging indicator (16) lights up. If the green end of charge indicator (17) lights up now instead, the battery is too hot and cannot be charged. If this happens, remove the battery from the charger, let the battery cool down for approx. 1 hour and re-insert it. After approx.
Your charger does not require any maintenance apart from regular cleaning. ◆ ◆ Warning! Before performing any maintenance on the tool, remove the battery from the tool. Unplug the charger before cleaning it. ◆ ◆ ◆ ◆ ◆ ◆ ◆ After use disconnect the battery and check the tool for any damage. Regularly clean the ventilation slots in your tool and charger using a soft brush or dry cloth. Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner.
T e c h n ic a l d a ta Voltage No-load speed Weight VDC min-1 kg BST2018 18 6,800 3.2 Battery Voltage Capacity Weight VDC Ah kg 18 1.7 0.8 Charger Voltage (Australia & New Zealand) Approx.
Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt. Wellington, Auckland. XXXXXX-00 (AUS) 12 Tel.
