Please Read and Save this Use & Care Book Por favor Jea este instructivo antes de usar el producto VeuiJJez Jire et conserver ce guide d'entrefien ROOM AIR et d'ufilisafion CONDITIONER BWE15A _ BWE18A _ BWE25A
AIRCONDITIONER SAFETY Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING.
8) Do not placeany objecton the top of the unit. 9) Neveroperatethe air conditionerwithoutthe filters in place. 10) Do not use the air conditionerneara bathtub,showeror washbasin. SAVETHESEHNSTRUCTIONS CAUTION! If the air conditioner has been placed time, wait 24 hours before plugging in a horizontal or tilted position for any period of the unit in. ProductRegistration Record Your Model and Serial Number. Attach the sales receipt to this guide and keep for future reference.
o Please ® Do not use liquid or a spray to clean this product. o Never spill liquid on the control panel; it may cause electrical and disable them or cause them to function improperly. keep this manual in a safe place, Use a damp cloth. shock to the electronic parts inside Never try, to dismantle the product by yourself as this will void the warranty. Unsupervised dismantling and incorrect reassembly of the inside of the back cover may damage the electrical circuit and affect its performance.
! @i?ili:ii;i:i()!:i !::ii!::,i:=!:(:iiili:iiiii_;!)i%ii!%_L!!!i; IMPORTANT: Observe all governing codes and ordinances. Check the location where the air conditioner will be installed. Make sure you have everything necessary for correct installation. The location should provide: Grounded electrical outlet within 4 ft (122 cm) of where the power cord exits the air conditioner. NOTE: Do not use an extension cord. Free movement of air in room to be cooled. A large enough opening for the air conditioner.
Power Supply Cord NOTE: Your air conditioner's shown, device may differ from the one Electrical Shock Hazard Plug into a grounded 3 prong outlet, Do not remove ground prong, Do not use an adapter, Do not use an extension A. Test button B. Reset button cord. Failure to follow these instructions can result in death, fire, or electrical shock. This room air conditioner is equipped with a power supply cord required by UL.
1. Measure the width of the window opening. 2. Mark the center line on the inside windowsill. A. Width of window opening B. Center line CAUTION: Never expose plastic front or grille to extreme ten1. peratures. Assemble Curtain/Top channel NOTE: Attach curtains to the air conditioner before placing the air conditioner in window. 1. Attach foam gasket to top of case above holes as shown in Fig 3 with 3 short screws. Excessive Weight Use two or more people to move and install air conditioner, 2.
Install left & right installation bracket and as shown in fig. Install bolt(2 1/2" long flat head bolt and locknut) to the installation bracket and adjust them to proper length ,then use 4 short screws to fix the bracket on the case. 5, Install 1, outer case in window Place outer case in window. Lower sash until it rests behind front flange of top channel. Bottom channel must rest behind window sill. A B A_ouf 5° 0 __. C A. Top channel B. Window sash C. Bottom channel 6.
2, Place the window lock bracket as shown. Use a 1/s"drill bit to drill a starter hole through the hole in the window lock bracket and into the upper window. 3, Attach the window lock bracket to the upper window with one 3142"screw to secure the window in place. 4. Plug into a grounded 3 prong outlet. 5. Press RESET on the power supply cord. See "Electrical Requirements." Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter.
AIRCONDITIONERUSE Operating your air conditioner properly helps you to obtain the best possible results. This section explains proper air conditioner operation. iMPORTANT: - If you turn off the air conditioner, wait at least 3 minutes before turning it back on. This keeps the air conditioner from blowing a fuse or tripping a circuit breaker. Do not try to operate your air conditioner in the Cool mode when outside temperature is below 61°F (16°C).
To set the Timer to turn on the air conditioner, the previous settings: 1. Turn on the air conditioner. Temperature Press the TEMP/TIME up arrow button to raise the temperature. Each time you press or hold the TEMP/TIME up arrow button, the temperature witl go up I°F until it reaches 90°F (32°C). NOTE: After 5 seconds, the display witt show the current room temperature. changing 2. Adjust the mode to Fan, Cool, Energy Saver or Dry. 3.
NOTE: Remote control may differ in appearance. Temperature ........... Press the TEMP/TIME up arrow button to raise the temperature. Each time you press or hold the TEMP/TIME up arrow button, the temperature wilt go up I°F until it reaches 90°F (32°C). i Press the TEMP/TIME down arrow button to lower the temperature. Each time you press or hold the TEMP/TIME down arrow button, the temperature wilt go down I°F until it reaches 61°F (16°C). NOTE: Two AAA Batteris (included) powers the remote control.
4. Adjust the temperature 30°C). between 61°F and 86°F (16°C and NOTE: In Fan mode, the temperature cannot be set. 4-Way Air Flow:The air directional louvers let you control the 5. Wait 3 seconds before turning off the air conditioner. direction of the airflow to the desired direction.The 6. Press TIMER. Timer On indicator light on the air conditioner control panel will flash. Display wilt show remaining hours before the air conditioner will turn on. directed up-down,left-right. 7.
3. Use a vacuum cleaner to clean air filter. If the air filter is very dirty, wash it in warm water with a mild detergent. Do not wash the air filter in the dishwasher or use any chemical cleaners. Air dry the air filter completely before replacing to ensure maximum efficiency. 4. Replace the air filter. 5. 6. Close the front panel. Turn on the air conditioner. 1. Turn off the air conditioner. 2. Clean the front panel with a soft, damp cloth. 3. Air dry the front panel completely. 4.
An extension cord is being used. Do not use an extension cord with this or any other appliance. You are trying to restart the air conditioner too soon after turning off the air conditioner. Wait at least 3 minutes after turning off the air conditioner before trying to restart the air conditioner. Air conditioner pops out) power supply cord trips (Reset button Disturbances in your electrical current can trip (Reset button will pop out) the power supply cord.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii !i ! @ ! !i i!!i!! i! i! i! i! i! i! i! i! i! i! i! i! i! i! i! i! i! i! i! ! @ @ What is covered and for how THIS WARRANTY COVERS APPLIANCES WITHIN THE CONTINENTAL UNITED STATES, PUERTO RICO AND CANADA.
Black & Decker and the Black & Decker logo are trademarks of The Black & Decker Corporation and are used under license. All rights reserved. La mention Black & Decker et le logo Black & Decker sont des marques de commerce d_pos6es de Black & Decker Corporation et sont utilis6s en vertu d'une licence. Tousdroits r_serv6s. Black & Decker y el Iogotipo de Black & Decker son marcas comercides de The Black & Decker Corporation y se usan con licencia. Todos los derechos reservados.