CS355
ENGLISH (Original instructions) Intended use Your Black & Decker Chop Saw has been designed for the cutting of variously shaped steel materials. This product is intended for consumer use only. Safety instructions General power tool safety warnings @ u u u Warning! When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and personal injury.. Read all of this manual carefully before using the appliance.
(Original instructions) 16. Remove adjusting keys and wrenches Always check that adjusting keys and wrenches are removed from the tool before operating the tool. 17. Avoid unintentional starting Do not carry the tool with a finger on the switch. Be sure that the tool is switched off before plugging in. 18. Use outdoor extension cables Before use, inspect the extension cable and replace if damaged. When using the tool outdoors, only use extension cables intended for outdoor use and marked accordingly. 19.
ENGLISH u u u (Original instructions) Regularly clear the ventilation slots when working in dusty conditions. If it should become necessary to clean the slots, remember to unplug the tool first. Always store cutting discs well-protected and in a dry place, out of reach of children. Warning!Use of this tool can generate dust containing chemicals known to cause cancer, birth defects or other reproductive harm. Use appropriate respiratory protection.
(Original instructions) u u u u u u u Replace the cutting disc (J). Make sure that the new disc is placed onto the spacer (R) in the correct rotational direction. Secure the blade with the retaining flange (U), the washer (T) and the bolt (S). Push in the spindle lock (L). Rotate the cutting disc (J) until it locks. Using the flat wrench (G), tighten the bolt (S) by turning clockwise. Move the guard back down and release the spindle lock (L). Adjust the cutting depth as necessary.
(Original instructions) ENGLISH Maximum cutting capacity Note: Capacity shown on chart assumes no wheel wear and optimum fence position.
(Original instructions) Repairs To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. Lubrication Closed-type, grease-sealed ball bearings are used throughout. These bearings have sufficient lubrication packed in them at the factory to last the life of the chop saw.
ENGLISH (Original instructions) EC declaration of conformity % MACHINERY DIRECTIVE CS355 Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN61029-1, EN61029-2-10 For more information, please contact Black & Decker at the following address or refer to the back of the manual. The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Black & Decker.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country .
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90566365 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
