Operation Manual
8
ENGLISH
Installation
Fitting the charging base to the
wall(g.B)
The charging base can be placed on a
worktop or tted to the wall to provide a
convenient storage and charging point
for the appliance.
Assembly
Fittingtheaccessories(g.A&C)
These models are supplied with the
following accessories:
u a crevice tool (7) for conned spaces
u a brush tool (8) for furniture and stairs
To t an accessory, proceed as follows:
u Take the accessories from the
appliance.
u Insert the appropriate accessory into
the front of the appliance.
Use
u Before rst use, the battery must be
charged for at least 24 hours.
u Place the appliance on the charging
base whenever it is not in use.
Chargingthebattery(g.B)
u Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch in the
on position.
u Place the appliance on the charging
base as shown.
u Plug in the charger. Switch on at the
mains.
The charging indicator (6) will be lit.
u Leave the appliance to charge for at
least 24 hours.
Whilst charging, the charger may
become warm. This is normal and does
not indicate a problem. The appliance
can be left connected to the charger
indenitely. The charging indicator will be
lit as long as the appliance is connected
to the plugged-in charger.
Warning! Do not charge the battery at
ambient temperatures below 10 °C or
above 40 °C.
Switchingonandoff(g.D)
u To switch the appliance on, slide the
on/off switch (1) forward.
u To switch the appliance off, slide the
on/off switch back.
CV1205/CV9605 - Optimising the
suctionforce(g.E)
In order to keep the suction force
optimised, the lter must be cleared
regularly during use.
u Rotate the wheel (5) a few turns to
shake out dust clogging the lter (9).
Cleaning and maintenance
Warning! Regularly clean the lters.
Cleaningthedustbowlandlters
(g.F-J)
The lters are re-usable and should be
cleaned regularly.
u Press the release button (2) and
remove the dust bowl (3) (g. F).
u Empty the dust bowl (g. G).
u Remove the lters (9 & 10) by
twisting them clockwise (g. H).
u Brush any loose dust off the lters.
u Wash the lters in warm, soapy water
(g. I). The bowl can also be washed
if necessary. Do not immerse the
appliance in water (g. J).
u Make sure the dust bowl and lters
are dry.
u Ret the lters (9 & 10) onto the
appliance, twisting them
counterclockwise until they lock into
place.
u Ret the dust bowl onto the
appliance. Make sure the dust bowl
clicks into place.
Warning! Never use the appliance
without the lters. Optimum dust
collection will only be achieved with clean
lters and an empty dust bowl.
CV1205/CV7205/CV9605 -
Cleaningtheexhaustlter(g.K)
u Open the lid (11).
u Remove the lter (12) from the recess.
u Wash the lter in warm, soapy water.
u Make sure the lter is dry.
u Ret the lter (12).
u Close the lid.