® www.blackanddecker.com.
A B C D E 2
(Original instructions) Intended use Your Black & Decker drill/screwdriver has been designed for screwdriving applications and for drilling in wood, metal and plastics. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
(Original instructions) Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.) # ENGLISH Electrical safety Labels on tool Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug.
ENGLISH (Original instructions) Use Charger diagnostics Warning! Let the tool work at its own pace. Do not overload. If the charger detects a weak or damaged battery, the follows: Re-insert the battery (5). easily done before. The battery may become warm while charging; this is normal and does not indicate a problem. Warning! Do not charge the battery at ambient temperatures below 4 °C or above 40 °C. Recommended charging temperature: approx. 24 °C.
(Original instructions) Drilling/screwdriving u u u Select forward or reverse rotation using the forward/ reverse slider (2). To switch the tool on, press the switch (1). The tool speed depends on how far you press the switch. To switch the tool off, release the switch. Hints for optimum use Drilling u Always apply a light pressure in a straight line with the drill bit. u Just before the drill tip breaks through the other side of the workpiece, decrease pressure on the tool.
(Original instructions) ENGLISH Technical data EGBL108-XE 10.8 Voltage V No-load speed Min Max. torque Nm 12/24 Chuck capacity mm 10 mm 10/25 DC 0-600 -1 Max Drilling capacity Steel/wood Charger Input Voltage V 230 Output Voltage V 10.8 Current A 2.0 min 30 AC DC Approx. charge time Battery BL1110 BL1310 BL1510 Voltage V 10.8 10.8 10.8 Capacity Ah 1.1 1.3 1.
E16062 6 5 Partial support - Only parts shown available Nur die aufgefuerten teile sind lieferbar Reparation partielle - Seules les pieces indiquees sont disponibles Supporto parziale - Sono disponibili soltanto le parti evidenziate Solo estan disponibles las peizas listadas So se encontram disponiveis as pecas listadas Gedeeltelijke ondersteuning - alleen de getoonde onderdelen zijn beschikbaar www.2helpU.com 1 2 EGBL108-XE 3 22 - 04 - 10 8 7 TYP.
Australia Stanley Black & Decker 82 Taryn Drive, Epping Vic, 3076, Australia New Zealand Stanley Black & Decker 90583364 Tel. 1800 444 224 Tel.