EGBL14 EGBL18
A B D 2 C
(Original instructions) Intended use Your Black & Decker drill/screwdriver has been designed for screwdriving applications and for drilling in wood, metal and plastics. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
(Original instructions) u u u Injuries caused by prolonged use of a tool. When using any tool for prolonged periods ensure you take regular breaks. Impairment of hearing. Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.
ENGLISH (Original instructions) Assembly Warning! Before assembly, remove the battery from the tool. Fitting and removing the battery (fig. B) u u To fit the battery (5), line it up with the receptacle on the tool. Slide the battery into the receptacle and push until the battery snaps into place. To remove the battery, push the release button (9) while at the same time pulling the battery out of the receptacle. Fitting and removing a drill bit or screwdriver bit (fig.
(Original instructions) u u u u Use HSS drill bits when drilling in metal. Use masonry bits when drilling in soft masonry. Use a lubricant when drilling metals other than cast iron and brass. Make an indentation using a centre punch at the centre of the hole to be drilled in order to improve accuracy. Screwdriving u Always use the correct type and size of screwdriver bit. u If screws are difficult to tighten, try applying a small amount of washing liquid or soap as a lubricant.
ENGLISH (Original instructions) EC declaration of conformity Technical data EGBL14 (H1) EGBL18 (H1) 14,4 18 0-650 0-650 Voltage V No-load speed Min Max. torque Nm 12/23 15/28 Chuck capacity mm 10 10 DC -1 Max Drilling capacity mm Steel/wood 10/25 10/25 Charger 905902** (typ. 1) Input Voltage V Output Voltage V Current mA Approx. charge time h 100 - 240 AC 8 - 20 DC Battery Voltage V Capacity Ah DC Type 400 3-5 BL1314 BL1514 BL1318 BL1518 14.4 14.
(Original instructions) ENGLISH Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90603052 REV-1 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
