GPC1800 GPC1800P
ENGLISH (Original instructions) Intended use Your Black & Decker cordless pole pruner has been designed for pruning trees. This tool is intended for consumer use only. Your Black & Decker charger has been designed for charging Black & Decker batteries of the type supplied with this tool. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions.
(Original instructions) Power tool use and care • Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. • Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
ENGLISH (Original instructions) • Do not attempt to cut a branch when the diameter of the branch exceeds the cutting length of the tool. • Always remove the battery from the tool and place the chain cover over the chain when storing or transporting the tool. • Keep the saw chain sharp and properly tensioned. Check the tension at regular intervals. • Switch the tool off, allow the chain to stop and remove the battery from the tool before carrying out any adjustment, servicing or maintenance.
(Original instructions) Warning symbols The following warning symbols are found on the tool: : R H g K n Warning! To reduce the risk of injury, the user must read the instruction manual. Do not use the tool in wet conditions or expose it to rain. Always wear head and eye protection. Wear non-slip safety footwear. Beware of falling objects. Keep bystanders away.
ENGLISH x j # (Original instructions) The charger automatically shuts off if the ambient temperature becomes too high. As soon as the ambient temperature has cooled down, the charger will resume operating. Charge only at ambient temperatures between 10 °C and 40 °C. Electrical safety Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate.
(Original instructions) After several charge and discharge cycles, the battery will attain full capacity. The battery may become warm while charging; this is normal and does not indicate a problem. Warning! Do not charge the battery at ambient temperatures below 10 °C or above 40 °C. Recommended charging temperature: approx. 24°C. • To charge the battery (11), remove it from the tool and insert it into the charger (12). The battery will only fit into the charger in one way. Do not force.
ENGLISH (Original instructions) • Place the new saw chain in the groove of the guide bar and around the sprocket. Make sure that the teeth are facing the correct direction by matching the arrow on the saw chain with the arrow on the housing. • Make sure that the slot (20) in the guide bar is over the location pins (21) and that the hole (22) below the slot is located over the adjustment pin (23). • Re-fit the sprocket cover (5) and the bar clamp (17) and the screws (16).
(Original instructions) Z Batteries • • • • At the end of their useful life, discard batteries with due care for our environment Do not short-circuit the battery terminals. Do not dispose of the battery(s) in a fire as this may result in a risk of personal injury or an Explosion. Run the battery down completely, then remove it from the tool. Batteries are recyclable. Place the battery(s) in a suitable packaging to ensure that the terminals cannot be short-circuited.
ENGLISH (Original instructions) Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
E14125 3 29 866 12 871 21 11 8 10 18 23 26 5 2 22 20 24 18 4 800 25 www.2helpU.com 27 6 18 7 21 16 28 GPC1800(P) - GPC1800NM 14 8 1 18 - 01 - 10 13 15 H2 TYP.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 Tel. 03-8720 5100 Fax 03-9727 5940 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 Tel. +64 9 259 1133 Fax +64 9 259 1122 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD Tel.