GTC800L
English 2 (Original instructions) 5
A B C D E 3
F1 F2 G H 4
Intended use f. If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. Your Black & Decker charger has been designed for charging Black & Decker batteries of the type supplied with this tool. 3. Personal safety a. Stay alert, watch what you are doing and use common sense when operating a power tool.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
Safety of others u u This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Do not expose the charger to water. Do not open the charger. u Do not probe the charger. The following symbols are found on your charger: u Fitting and removing the trimmer head (fig. C) u # $ + Your charger is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug. The charger is intended for indoor use only.
connected indefinitely with the LED illuminated. The LED will change to flashing (charging) state as the charger occasionally tops off the battery charge. The charging indicator (9) will be lit as long as the battery is connected to the plugged-in charger. u Charge discharged batteries within 1 week. Battery life will be greatly diminished if stored in a discharged state. Charging indicators If the charger detects a problem with the battery, the charging indicator (9) will flash at a fast rate.
u Before using the tool after prolonged storage, fully charge the battery again. u Troubleshooting If the tool does not operate correctly, check the following. Fault Possible cause Tool will not start. Battery not installed properly. Check the battery installation. Battery discharged. Action Fit a (fully) charged battery. Lock-off button not actuated. Observe the starting procedure. Pole connections not properly Check the connections. tightened. Battery will not charge.
EC declaration of conformity % MACHINERY DIRECTIVE OUTDOOR NOISE DIRECTIVE GTC800L Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60745-1, EN 60745-2-15 2000/14/EC, Hedge trimmer 1400 min-1, Annex V LWA (measured sound power) 93 dB(A), Uncertainty (K) 3dB(A) LWA (guaranteed sound power) 95 dB(A), Uncertainty (K) 3dB(A) These products also comply with directive 2004/108/EC.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90587059 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
