HP146F4L HP186F4L HP148F4L HP188F4L
English 2 (Original instructions) 5
A B C D E F 3
G 4
Intended use Your Black & Decker drill/screwdriver has been designed for screwdriving applications and for drilling in wood, metal, plastics and soft masonry. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5. Battery tool use and care a.
u u Impairment of hearing. Health hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.) Labels on tool : The following pictograms are shown on the tool: Warning! To reduce the risk of injury, the user must read the instruction manual. Additional safety instructions for batteries and chargers Batteries u Never attempt to open for any reason. u Do not expose the battery to water.
Fitting and removing a drill bit or screwdriver bit (fig. D) This tool is fitted with a keyless chuck to allow for an easy exchange of bits. u Lock the tool by setting the forward/reverse slider (2) to the centre position. u Open the chuck by turning it (3) with one hand while holding the tool with the other. u Insert the bit shaft (14) into the chuck. u Firmly tighten the chuck by turning it (3) with one hand while holding the tool with the other.
Drilling/screwdriving u u u Select forward or reverse rotation using the forward/ reverse slider (2). To switch the tool on, press the switch (1). The tool speed depends on how far you press the switch. To switch the tool off, release the switch. Hints for optimum use Drilling u Always apply a light pressure in a straight line with the drill bit. u Just before the drill tip breaks through the other side of the workpiece, decrease pressure on the tool.
Technical data Voltage VDC No-load speed min-1 Max. torque Nm Chuck capacity mm Max. drilling capacity steel/wood/masonry mm Battery cat. no. Weight (without battery) kg HP146F4L(H2) 14.4 0-350/0-1,200 28 13 HP148F4L(H2) 14.4 0-350/0-1,200 29 13 13/19 A1514L 1.33 13/19/13 A1514L 1.38 Voltage VDC No-load speed min-1 Max. torque Nm Chuck capacity mm Max. drilling capacity steel/wood/masonry mm Battery cat. no.
Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90561597 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
