Instruction manual

5
Controls and Indicators
Applications
• Jump-start most vehicle batteries with a standard 12 volt DC system: small truck, car, RV, tractor, etc.
• Operate (using 5 amp rated 12 volt DC accessory outlet): 12 volt DC fans, fluorescent worklights, air
compressors, spotlights, TVs, portable radios, cassette or CD players, and more. The unit can quick-charge a
cellular phone by using the phone’s 12 volt DC adapter cord.
• Illuminate areas under the hood, inside tents and work areas.
• Inflate (using inflator) tires, air mattresses, basketballs, volleyballs, and more.
JUMP-STARTER
This Jump-Starter is equipped with an ON/OFF Power Switch. Once the connections are properly made, turn the
switch ON to jump-start the vehicle.
1 . Turn OFF vehicle ignition and all accessories (radio, A/C, lights, connected cell phone chargers, etc.). Place
vehicle in “park” and set the emergency brake.
2 . Make sure the Jump-Starter Power Switch is turned to OFF.
3 . Remove jumper clamps from clamp tabs. Connect the red clamp first, then the black clamp.
NOZZLES
1 . Built-in LED Emergency Area Light
2 . Reverse Polarity Indicator
3 . 12 Volt DC Outlet
4 . B a t t e r y Charge Level Pushbutton
5 . LED Battery Status Indicators
6 . Jump-Starter Power Switch
7. Area Light Power Switch
8. Built-in 120 Volt AC Charger
9 . Pressure Gauge
1 0 . Inflator Power Switch
1 1 . Negative (–) Black Clamp
1 2 . Positive (+) Red Clamp
1 3 . Air Hose
1 4 . Connector (Chuck)
Front View Back View
3
2
4
5
9
10
14
13
11 12
8
6
1
7
JS450CP ManualEN 062807.qxp 9/26/08 12:42 PM Page 5