Powerful Solutions www.blackanddecker.co.
English 2 (Original instructions) 4
Intended use Your Black & Decker sander has been designed for sanding wood, metal, plastics and painted surfaces. This tool is intended for consumer use only. Safety instructions General power tool safety warnings ! Warning! Read all safety warnings and all instructions. Failure to follow all instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f.
Electrical safety This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard. Features 1. On/off switch 2. Dustbag 3. Dust extraction outlet 4. Sanding base 5. Paper clamp lever Assembly Warning! Before assembly, make sure that the tool is switched off and unplugged.
When sanding new layers of paint before applying another layer, use extra fine grit. On very uneven surfaces, or when removing layers of paint, start with a coarse grit. On other surfaces, start with a medium grit. In both cases, gradually change to a fine grit for a smooth finish. Consult your retailer for more information on available accessories. Maintenance Your Black & Decker tool has been designed to operate over a long period of time with a minimum of maintenance.
EC declaration of conformity MACHINERY DIRECTIVE KA400 Black & Decker declares that these products described under "technical data" are in compliance with: 98/37/EC (until Dec. 28, 2009), 2006/42/EC (from Dec. 29, 2009), EN60745-1, EN60745-2-4 For more information, please contact Black & Decker at the following address or refer to the back of the manual. The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Black & Decker.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
$XVWUDOLD %ODFN 'HFNHU $XVWUDOLD 3W\ /WG )OHWFKHU 5RDG 0RRURROEDUN 9LFWRULD 1HZ =HDODQG %ODFN 'HFNHU 7H $SXQJD 3ODFH 0W :HOOLQJWRQ $XFNODQG 8QLWHG .
