KD975 KD985 KD990
English 2 (Original instructions) 5
A B C D E 3
F 4
Intended use Your Black & Decker rotary hammer drill has been designed for drilling in wood, metal, plastics, and masonry as well as for screwdriving and light chiselling applications. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5. Service a.
Fitting the side handle and depth stop (fig. A) u u u u u Turn the grip counterclockwise until you can slide the side handle (7) onto the front of the tool as shown. Rotate the side handle into the desired position. Insert the depth stop (8) into the mounting hole as shown. Set the depth stop to the desired position. The maximum drilling depth is equal to the distance between the tip of the drill bit and the front end of the depth stop. Tighten the side handle by turning the grip clockwise.
Switching on and off u u u u u To switch the tool on, press the variable speed switch (1). The tool speed depends on how far you press the switch. Set the variable speed control knob (4) to the required speed range. Use speeds 1-6 for short periods only. As a general rule, use low speeds for large diameter drill bits and high speeds for smaller diameter drill bits. For continuous operation, press the lock-on button (2) and release the variable speed switch.
Vibration total values (triax vector sum) according to EN 60745: Hammer drilling into concrete (ah, HD) 10.8 m/s2, uncertainty (K) 1.5 m/s2 Chiselling (ah, Cheq) 8.5 m/s , uncertainty (K) 1.5 m/s 2 2 EC declaration of conformity % MACHINERY DIRECTIVE KD975/KD985/KD990 Black & Decker declares that these products described under "technical data" are in compliance with: 98/37/EC (until Dec. 28, 2009), 2006/42/EC (from Dec.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90557455 REV-0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
