www.blackanddecker.
Intended use Your Black & Decker jigsaw has been designed for sawing wood, plastics and sheet metal. This tool is intended for consumer use only. General safety rules Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. SAVE THESE INSTRUCTIONS. 1. Work area a.
. Service a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will make sure that the safety of the power tool is maintained. Electrical safety This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate. Additional safety instructions for non-rechargeable batteries X Never attempt to open for any reason.
Fitting and removal of the side handle (fig. B) X The side handle (4) can be fitted to either the left or right side of the tool. X Align and insert the side handle (4) into the location on the tool, then rotate it towards the rear until it locks into place. X To remove, rotate it towards the front until it stops, then pull it out of the location. Connecting a vacuum cleaner to the tool (fig. C & D) X Attach the dust extraction adaptor (9) to the shoe plate (8) as shown.
Sawing metal X Be aware that sawing metal takes much more time than sawing wood. X Use a saw blade suitable for sawing metal. X When cutting thin sheet metal, clamp a piece of scrap wood to the back surface of the workpiece and cut through this sandwich. X Spread a film of oil along the intended line of cut. Accessories The performance of your tool depends on the accessory used.
Technical data KS1000E/KS1000NL/KS1001E/KS1002E Power input W 710 Number of strokes (no load) min-1 800-3,200 Max depth of cut Wood mm 85 Steel mm 4 Aluminium mm 10 EC declaration of conformity KS1000E/KS1000NL/KS1001E/KS1002E Black & Decker declares that these products conform to: 98/37/EC, 89/336/EEC, EN 60745, EN 55014, EN61000, IEC 60825+A1+A2:2001 LpA (sound pressure) 88 dB(A), LWA (acoustic power) 99 dB(A), hand/arm weighted vibration <6.
KS1000E - KS1000NL KS1001E - KS1002E TYP 1 24 41 42 6 43 35 7 36 25 5 4 821 48 2 39 20 27 31 17 32 19 1 26 49 41 KS1000NL 11 12 13 4 3 GB 50 34 45 33 10 14 44 40 16 18 46 15 47 E14729 37 38 22 21 9 www.2helpU.
90501321 06/06
