2 1 6 ™ ol tr on eC rv Cu 3 5 4 www.blackanddecker.
7 8 3 5 B A 11 10 C 6 D 12 12 0 PVC 3 2 1 6 E 2 KS901PE F KS801SE KS901SE
13 15 4 G H 14 16 I K J 3
ENGLISH (Original instructions) Intended use Your BLACK+DECKER jig saw has been designed for sawing wood, plastics and metal. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
(Original instructions) binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
ENGLISH (Original instructions) Electrical safety # u This tool is double insulated; therefore no earth wire is required. Always check that the power supply voltage corresponds to the voltage on the rating plate. If the supply cord is damaged, it must be replaced by the manufacturer or an authorised BLACK+DECKER Service Centre in order to avoid a hazard. Features This tool includes some or all of the following features. 1. Variable speed switch (KS901PE) or On/Off switch (KS801SE and KS901SE) 2.
(Original instructions) ENGLISH Pendulum Stroke dial (fig. E - KS901PE only) The KS901PE has these four cutting modes with increasing amounts of pendulum action: u Position 0: metal and aluminium and sheet metal (no pendulum action). u Position 1: for laminates, hard wood, work tops. u Position 2: for plywood and PVC/Plastics. u Position 3: for soft wood and fast cutting To adjust the pendulum action: u Rotate the Pendulum Stroke dial (6) to the required position. Auto Select™ dial (fig.
ENGLISH u u u (Original instructions) Use a fine-tooth saw blade. Saw from the back surface of the workpiece. To minimise splintering, clamp a piece of scrap wood or hardboard to both sides of the workpiece and saw through this sandwich. Alternatively, fit the anti-splinter guard (13) that is supplied with your product. (KS901SE only). Sawing metal Warning! Do not use a vacuum when cutting metal. Metal filings will be hot and may cause fire.
(Original instructions) You can check the location of your nearest authorised repair agent by contacting your local BLACK+DECKER office at the address indicated in this manual. Alternatively, a list of authorised BLACK+DECKER repair agents and full details of our after-sales service and contacts are available on the Internet at: www.2helpU.
ENGLISH (Original instructions) Guarantee & Warranty Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your contractual rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
(Original instructions) ENGLISH 11
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 Tel. Fax 03-8720 5100 03-9727 5940 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Aukland 1060 Tel. Fax +64 9 259 1133 +64 9 259 1122 United Kingdom & Republic Of Ireland www.blackanddecker.co.uk emeaservice@sbdinc.com Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD Tel.
