Use and Care Manual

ASSEMBLY AND ADJUSTMENT

INSERTING AND REMOVING BITS

(FIGURE C)

• Before installing or removing bits, move the

forward/ reverse slider (1) to the center

“lock-off” position as shown in insert.

• To install a bit, insert it into the cavity in the

hex spindle as shown in figure C.

• To remove the bit pull it straight out.

• For bit tips, use a bit tip extender as shown.

NOTE: Only hex end bits will fit in spindle.

PIVOTING THE TOOL HANDLE

(FIGURES D, E)

• The handle of the tool can be pivoted into

three positions for optimum versatility as

shown in figure D.

• To pivot the tool handle, press the pivot

release button (2) as shown in figure E.

• Release the button in any one of the two

remaining locked positions.

WARNING: Check to make sure tool

handle is locked after pressing pivot

release button and changing screwdriver

positions.

WARNING:

• To avoid being pinched at the areas

indicated with black arrows, hold the

screwdriver at both ends and use your

thumb to depress the pivot release button when changing positions.

• Do not use screwdriver as a pry bar in any position.

• To avoid screwdriver being turned on accidentally, do not carry in your pocket.

OPERATING INSTRUCTIONS

OPERATING IN POWER MODE

Forward

• Rotate the collar (4) to the position marked as shown in figure F.

• Slidetheforward/reverseswitch(1)totheright,exposingthearrowpointingforwardasshowninfigureF.

• Press the button on the switch and the tool will run; release the button and the tool will stop.

Reverse

• Rotate the collar (4) to the position marked as shown in figure F1.

• Slide the forward/reverse switch (1) to the left, exposing the arrow pointing backward.

• Press the button on the switch and the tool will run; release the button and the tool will stop.