www.blackanddecker.co.
15 16 21 14 13 A 20 17 18 19 3 B 23 19 6 C 2 22 D
24 11 10 180 o 8 13 F E 27 14 26 25 11 10 G H 30 28 29 26 I 5 J 3
Intended use Your Black & Decker multi-purpose tool has been designed for a wide range of DIY applications. Using the screwdriver head, this tool is intended for screwdriving applications. Using the sander head, this tool is intended for sanding wood, metal, plastics and painted surfaces. Using the preparation head, this tool is intended for scraping decorating materials, such as paint layers and adhesives, from wood, metal and plastics. This tool is intended for consumer use only.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5. Service a.
◆ ◆ To remove the screwdriver bit from the bit storage press the bit down into the bit holder recess (4), then lift the bit out. To store the screwdriver bit, firmly push it into the storage. Fitting sanding sheets (fig. D) ◆ Detach the two diamond-shaped tips (23) from the sanding sheet (19). ◆ Hold the tool with the sanding base facing upwards. ◆ Place the sanding sheet (19) onto the sanding base, making sure that the holes in the sheet line up with the holes in the base.
Sanding ◆ Do not exert too much pressure on the tool. ◆ Regularly check the condition of the sanding sheet. Replace when necessary. ◆ When sanding new layers of paint before applying another layer, use extra fine grit. ◆ On very uneven surfaces, or when removing layers of paint, start with a coarse grit. On other surfaces, start with a medium grit. In both cases, gradually change to a fine grit for a smooth finish. ◆ Use the abrasive pad for removing rust.
EC declaration of conformity MT3000K Black & Decker declares that these products conform to: 98/37/EC, 89/336/EEC , 2002/95/EC, EN 60745 , EN 55014 , EN 61000 LpA (sound pressure) 80 dB(A), LWA (acoustic power) 91 dB(A), hand/arm weighted vibration 6,1 m/s2 KpA (sound pressure uncertainty) 3 dB(A), KWA (acoustic power uncertainty) 3 dB(A) Kevin Hewitt Director of Consumer Engineering Spennymoor, County Durham DL16 6JG, United Kingdom 1-12-2004 Guarantee Black & Decker is confident of the quality of its pro
MT3000K 33 TYP 1 1 4 3 5 6 19 8 2 17 18 7 10 9 16 12 13 39 19 14 35 15 34 36 20 11 26 29 30 28 27 22 21 24 31 32 E14110 23 25 WWW.2helpU.
Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker 81 Hugo Johnston Drive Penrose, Auckland, New Zealand United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 487779-00 12 Tel. 09 579 7600 Fax 09 579 8200 Tel.
