PP360
A B C D E 2
(Original instructions) Intended use Your Black & Decker Pivot Driver™ has been designed for screwdriving applications. These applications include driving screws in tight locations, such as close to edges and corners and against ceilings and floors, etc. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions.
ENGLISH (Original instructions) d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use.
(Original instructions) Labels on tool : The following pictograms are shown on the tool: Warning! To reduce the risk of injury, the user must read the instruction manual. Electrical safety # Additional safety instructions for batteries and chargers u Batteries u Never attempt to open for any reason. u Do not expose the battery to water. u Do not expose the battery to heat. u Do not store in locations where the temperature may exceed 40 °C.
ENGLISH (Original instructions) The charger may hum and become warm while charging; this is normal and does not indicate a problem. Generally, a charging time of 8 hours will enable the tool to operate at an effective power level for most tasks. However, further charging for up to 10 hours could significantly increase the run time, depending on the battery and charging conditions. Warning! Do not charge the battery at ambient temperatures below 4 °C or above 40 °C.
ENGLISH (Original instructions) Warning! Before performing any maintenance on the tool, remove the battery from the tool. Unplug the charger before cleaning it. u Regularly clean the ventilation slots in your tool and charger using a soft brush or dry cloth. u Regularly clean the motor housing using a damp cloth. Do not use any abrasive or solvent-based cleaner. Technical data Voltage VDC No-load speed min-1 Max. torque Nm Bit holder Weight kg Protecting the environment Battery Voltage V 4.
ENGLISH (Original instructions) Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Auckland 1060 United Kingdom Black & Decker 210 Bath Road Slough, Berkshire SL1 3YD 90584938 REV 0 Tel. 03-8720 5100 Fax 03-9727 5940 Tel. +64 9 259 1133 Fax +64 9 259 1122 Tel.
