Installation guide

Chapter 5: Installing a BlackDiamond X8 Series Chassis
BlackDiamond X8 Series Switches Hardware Installation Guide
56
4 Slide the power supply into the chassis until the lever starts to engage (Figure 4.
Figure 24: Installing a Power Supply
5 Rotate the lever toward the front of the power supply to fully seat the power supply in the chassis.
6 Repeat steps 3 through 5 to install other power supplies as required by your system configuration.
7 Replace the power supply ventilation cover as follows:
a Set the lower edge of the cover in place so that the tabs on the edge fit into the matching slots in
the chassis frame (Figure 25).
b Rotate the top of the cover into place against the front of the chassis frame.
c Align and tighten the retaining screws.
CAUTION
Do not operate the BlackDiamond X8 switch without the power supply cover in place. This cover is
required to maintain proper EMI levels for the switch.
BDX_018