User Manual
Instruction manual HE-111 Item code: BH143
8
INSTALLING THE AILERONS AND FLAPS
INSTALLING THE AILERONS AND FLAPS SERVOS
Temporary pin to
keep hinge centered
Make certain the hinges are adequately
secured with glue. If they come loose in fight accidents
may result.
1 Secure nylon hinges with instant glue, being careful
not to glue the wing and aileron together.
2 Align the center line of main wing with aileron.
1
2
C.A
C.A
Bottom view
1) Install the rubber grommets and brass eyelets onto
the aileron servo.
2) Using a modeling knife, remove the covering from
over the servo box.
3) Place the servo into the servo tray. Center the servo
within the tray and drill 1.5mm pilot holes through the
1) Test fit the aileron to the wing with the hinges. If the
hinges dont’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
2) Apply drops of thin CA to the top and bottom of
each hinge. Do not use CA accelerator. After the CA has
fully hardened, test the hinges by pulling on the aileron.
block of wood for each of the four mounting screws
provided with the servo.
4) Using the thread as a guide and using masking tape,
tape the servo lead to the end of the thread: carefully pull
the thread out. When you have pulled the servo lead out,
remove the masking tape and the servo lead from the
thread.
5) Place the servo into the servo tray/ hatch into the
servo box on the bottom of the wing and drill 1.5mm
pilot holes through the tray and servo box for each of the
four mounting screws. Secure the servo tray in place
using the mounting screws provided.
6) Repeat step # 2 - # 5 to install the second aileron servo
in the opposite wing half.
Flap
Aileron
C . A
Apply instant glue
(C.A glue, super glue).
Warning!
Ensure smooth, non-binding
movement when assembling.