User Manual

FOCKE WULF Item code: BH178 Instruction Manual
Cut off shaded portion
Must be purchased separately!
1. Plug the throttle servo into the receiver and turn on
the radio system. Check to ensure that the throttle
servo output shaft is moving in the correct
direction. When the throttle stick is moved forward
from idle to full throttle, the throttle barrel should
also open and close using this motion. If not,
reverse the direction of the servo, using the
transmitter.
Apply threadlocker (screw cement).
Ensure smooth, non-binding movement
when assembling
Connector
1
INSTALLING THE THROTTLE
Drill holes using the stated.
(in this case 1.5mm ).
1
.5mm
Throttle servo
36
Fuselage Top Side
2mm
2mm
Linkage
stopper
4x4mm
2x10mm
2mm
Pushrod wire
Screw
Adjust the throttle input (trans-
mitter throttle stick), throttle trim
movement and the carburattor
opening to the suitable position
and screw in the 4x4mm set
screw.
Connector