User Manual

INSTRUCTION MANUAL
.
13
Remove covering.
1 2. Draw a center line onto the horizontal
stabilizer. Then slide the horizontal into the
fuselage.
Remove covering.
1 1. Using a modeling knife, cut the cover-
ing from the horizontal stabilizer and remove
it.
HORIZONTAL STABILIZER.
Check to mark sure the wing and stabi-
lizer are paralell. If they are not, lightly sand
the opening in the fuselage for the stabilizer
until the stabilizer is paralell to the wing.
See pictures below:
Temporary pin to
keep hinge centered.
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Cut the covering
away from the slot.
Center line.