User Manual

INSTRUCTION MANUAL
.
19
Snap keeper.
Throttle servo.
Rudder servo.
Throttle.
Elevator
servo.
Elevator
servo.
Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess material
from the arm.
After installing the adjustable metal
connector apply a small drop of thin C/A to
the bottom nut. This will prevent the connector
from loosening during flight.
Servo arm.
Connector.
INSTALLING THE THROTTLE
PUSHROD.
Cut
Throttle
pushrod
1 2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
1 1. Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
MOUNTING THE TAIL WHEEL BRACKET.
1 3. Secure the tail wheel bracket in place
using three 3mm x 12mm wood screws. Be
careful not to overtighten the screws.