User Manual

ULTIMATE.
24
1 1. Completely charge your transmitter and
receiver batteries before your first day of flying.
1 2. Check every bolt and every glue joint in
your plane to ensure that everything is tight
and well bonded.
1 3. Double check the balance of the
airplane.
1 4. Check the control surface.
1 5. Check the receiver antenna . It should
be fully extended and not coiled up inside the
fuselage.
1 6. Properly balance the propeller.
We wish you enjoy.
Ailerons : 20mm up 20mm down
Elevator : 30mm up 30mm down
Rudder : 30mm right 30mm left
1 1. We highly recommend setting up a plane
using the control throws listed.
1 2. The control throws should be measured
at the widest point of each control surface.
1 3. Check to be sure the control surfaces
move in the correct directions.
CONTROL THROWS.
Aileron Control
PRE-FLIGHT CHECK.
*If possible, first attempt to balance the model
by changing the position of the receiver
battery and receiver. If you are unable to obtain
good balance by doing so, then it will be
necessary to add weight to the nose or tail to
achieve the proper balance point.
105