User Manual

ULTIMATE.
4
1 4. Install servo tray with aileron servo into
the wing as same as picture below.
1 2. Locate nylon control horns, nylon con-
trol horn backplates and 3 machine screws.
Repeat the procedure for the right lower
wing half.
Wing.
Servo tray.
1 1. Using a ruler & pen to draw a straight
line as below picture.
Pen.
INSTALLING THE AILERON CONTROL HORN.
1 3. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out,
remove the masking tape and the servo lead
from the thread.
1 2. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into aileron
servo tray as same as picture below:
Remove covering.
Aileron sero tray.
Bottom of left lower wing
Servo wire.
2x10mm.