User Manual

1
9
4
5
7
6
8
3
2
NOTICE: Do not use E15 or E85 fuel in
this product. It is a violation of federal law
and will damage the unit and void your
warranty. Only use unleaded gasoline
containing up to 10% ethanol.
ENGINE STARTING PROCEDURE
WARNING:
This Engine Starting Procedure is not a substitute
for reading the operator’s manual. To reduce the
risk of injury, user must read and understand
operator’s manual before using this product.
1
2
3
4
5
6
7
8
9
Pull starter grip and rope until engine starts (6X max.)
NOTE: If the unit has not started, return to step 3.
SQUEEZE the throttle trigger to full throttle.
Allow the engine to warm for 10 seconds, SET choke lever to
RUN.
PRESS and HOLD stop switch until engine stops.
SET choke lever to RUN.
Pull starter grip and rope until engine starts (6X max.)
SQUEEZE the throttle trigger to full throttle.
Pull starter grip and rope handle until engine attempts to start
(4X max.)
SET choke lever to HALF choke.
SET choke lever to FULL choke.
50:1 Ratio = Mix 2.6 oz. 2-cycle lubricant with 1 gallon of fresh
gasoline in separate gas container. Shake, Pour into fuel tank.
Slowly press the PRIMER BULB 10x or until fuel appears.
TO STOP:
TO RESTART A WARM ENGINE:
If the engine/unit is already hot:
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
1 GALLON
GAS
LUBRICANT
Go to www.blackmax.com and register your new tool on-line.
For any questions about operating or maintaining your product,
call the BLACK MAX Help Line! Your product has been fully
tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
995000947
8-26-19 (REV:01)
CALL
1-800-726-5760
www.blackmaxtools.com